For the four-sided woodworking. Working width 220 mm (9"), working height 120 mn (5").

The machine is equipped with a through feed. Diameter of feed rollers 140 TIm (5.1/2"), width 100 TIm (4") (2 x 50 mm). Driven feed rollers in the machine table. Central adjustment of the upper spindle, feed rollers as well as of all pressure elements and equipped with switches for limitation of adjustment "up-down". The thicknessing spindle is also separately adjustable by handwheel according to scale graduated into 1/10 TIm (.004"). Rotation of the spindles per minute 6000. Horizontal spindles with counter bearings. High-capacity spindles with tolerance-free precision bail bearings. The machine is operated from the frontside and all spindles are adjustable up-down and laterally. All table plates as well as the right fences are hardened.

Motor equipment: All spindles 7.5 HP. The machine is equipped with complete electrical equipment. Operation for motor-driven adjustment "up-down", forward and reverse feed and emergencyJ stop is effected from the switchcase. Except the reverse feed these switches are also situated at the end of the machine.

The machine is equipped with standard operational tools, but without working tools.

D.L. Approved Electrics: Operating voltage:440 volts,60 cycles Spindle diameter I 13/16"
Manual waxilit pump to clean the machine table
Safety covers for feed rollers

MACHINE CONFIGURATICN CONSISTING OF:
Mechanical feed 10HP, 8 - 40 m/min / Straightening table 2 m long /
1st spindle bottom
2nd spindle right
3rd spindle left
4th spindle right
5th spindle top (bottom prepared)
6th spindle top
7th spindle bottom
8th spindle universal head

SPECIAL EXTRAS:
Working width 235m (9 1/4") on spindle 3 /'
Increase of motor power for spindles from 7.5 to 10HP spindles 3, 4 Increase of motor power for spindles from 7.5 to 15HP spindles 1,5,7
Increase of motor power for spindles from 7.5 to 20HP spindle 6.

Multiple height pressure shoe after top spindle (divided)
Infeed roller before 1st bottom spindle with pneumatic pressure instead of spring pressure with separate pressure adjustment

Additional in feed roller before 1st bottom spindle with idle roller in the infeed table (with pneumatic pressure)
New straightening-guiding rollers, including rebate unit

Spindle adjustment mechanical read-out for vertical spindle 3 up/down
Spindle adjustment mechanical read-out for vertical spindle 4 both axes
Spindle adjustment mechanical read-out for horizontal spindle 6 in/out
Spindle adjustment mechanical read-out for horizontal spindle 7 both axes

ATS System, automatic positioning control for spindles 3,6, up to 30 dimensions programmable per spindle, motorized adjustment via push button of both spindles to the pre-selected position, programmed tooling diameter is taken into consideration.

Measuring stand for tooling radius (ATS)

Hydraulic clamping for outboard bearing each top spindle spindles 5,6

Profile jointer right spindle per spindle 4 (Pneumatic, hydraulic incl. jointer stone adj., tele-controlled)
Min. cutting circle: 140 mm
Max. cutting circle: 250 mm

Profile jointer left spindle per spindle 3 Min. cutting circle: 140 mm
Max. cutting circle: 250 mm

Profile jointer top spindle per spindle 6 Min. cutting circle: 140 rom
Max. cutting circle: 250 mm

General condition : Very Good